Temperature- and frequency-dependent hysteresis scaling behaviour and phase transitions in a [001]c 0.73Pb(Mg1/3Nb2/3)O3-0.27PbTiO3 single crystal

The dielectric properties and bipolar polarization-electric field (P-E) and strain-electric field (S-E) dynamic hysteresis of a relaxor [001]_c 0.73Pb(Mg_1/3Nb_2/3)O₃-0.27PbTiO₃ (PMN-0.27PT) single crystal were investigated to reveal more details of the temperature-induced phase transitions. Different linear scaling relations for ferroelectric hysteresis area <A>, coercive field E_c, saturation polarization P_s and remnant polarization P_r versus temperature τ were measured in different temperature regions. For each measurement frequency f, all hysteresis parameters were found to decrease linearly with temperature in the temperature range of the single rhombohedral (R) phase or tetragonal (T) phase, and the rate of decrease in the T phase was observed to be much larger than the corresponding rate in the R phase. In the temperature range near the R-T phase transition, the exponent α in the power law <A>∝f ^α for the R phase was found to be smaller than that for the T phase, and the magnitude of α depended strongly on temperature when the crystal was in the R-T coexisting phase state. Our experimental and theoretical results indicate that the difference in the activation energy and dipole moment in the R and T phases may lead to the observed discrepancy for the P-E and S-E hysteresis behaviour in different temperature regions.     

工业汽轮机的清洗

本文介绍了用饱和蒸汽对冷凝式汽轮机进行清洗除垢时主要参数的确定、操作要点及清洗方案，清洗后的汽轮机运行正常。     

注高温热水管线缓蚀,阻垢实验研究

针对辽河油田高凝油区块注高温热水(85—95℃)引起的腐蚀、结垢,开展了室内和现场缓蚀、阻垢试验;分析了不同温度下注水的腐蚀情况,对比、考察了不同的缓蚀剂、阻垢剂及其复配物,得出了如下认识:在注高温热水条件下直接采用常温下使用的防腐蚀、防垢方法是不可行的,必须有针对性地进行高温条件下防腐蚀、防垢的实验研究工作。     

Unscented Kalman filter with advanced adaptation of scaling parameter

The paper deals with state estimation of the nonlinear stochastic systems by means of the unscented Kalman filter with a focus on specification of the σ$\sigma$-points. Their position is influenced by two design parameters—the scaling parameter determining the spread of the σ$\sigma$-points and a covariance matrix decomposition determining rotation of the σ$\sigma$-points. In this paper, a choice of the scaling parameter is analyzed. It is shown that considering other values than the standard choice may lead to increased quality of the estimate, especially if the scaling parameter is adapted. Several different criteria for the adaptation are proposed and techniques to reduce computational costs of the adaptation are developed. The proposed algorithm of the unscented Kalman filter with advanced adaptation of the scaling parameter is illustrated in a numerical example.     

Method of electrodialysis stack testing with the feed solution concentration regulation

A technique to test electrodialysis (ED) stacks designed to desalt dilute solutions is developed. The technique permits obtaining reproducible data on laboratory and medium-scale units useful for predicting mass transfer characteristics of large ED stacks. Quasi-steady state of desalination process is the main condition to obtain such data. This state can be attained by applying recycling hydraulic modes and special devices to maintain constant pH, or pH and concentration of the feed solution. To obtain data for scaling, it is necessary to apply a fixed voltage on the stack and to use a constant flow rate of the feed solution during the experiment, the feed solution concentration may vary with the time. Specifications of the stacks studied, rational hydraulic and electrical modes of testing are considered.     

Reynolds number scaling of flow in a Rushton turbine stirred tank. Part I—Mean flow, circular jet and tip vortex scaling

We consider scaling of flow within a stirred tank with increasing Reynolds number. Experimental results obtained from two different tanks of diameter 152.5 and 292.1 mm, with a Rushton turbine operating at a wide range of rotational speeds stirring the fluid, are considered. The Reynolds number ranges from 4000 to about 78,000. Phase-locked stereoscopic PIV measurements on three different vertical planes close to the impeller give phase-averaged mean flow on a cylindrical surface around the impeller. The scaling of θ- and plane-averaged radial, circumferential and axial mean velocity components is first explored. A theoretical model for the impeller-induced flow is used to extract the strength and size of the three dominant elements of the mean flow, namely the circumferential flow, the jet flow and the pairs of tip vortices. The scaling of these parameters with Reynolds number for the two different tanks is then obtained. The plane-averaged mean velocity scales with the blade tip velocity above a Reynolds number of about 15,000. However, parameters associated with the jet and tip vortices do not become Reynolds number independence until Re exceeds about 10⁵. The results for the two tanks exhibit similar Reynolds number dependence, however, a perfect collapse is not observed, suggesting a sensitive dependence of the mean flow to the finer details of the impeller.     

基于分而治之的多维标度算法

作为一种典型的多元统计分析方法,多维标度法(MDS)广泛应用于降维和可视化研究中.MDS从n个样本间的距离距阵出发,求取它们在低维欧氏空间的坐标.经典MDS算法(CMDS)的时间复杂度为Θ(n3),影响MDS的速度.文中基于分而治之的思想提出一种新的MDS算法.首先将距离矩阵沿对角线分成若干子矩阵,然后对每个子矩阵求解,最后通过正交变换和平移变换整合各子矩阵的解,从而得到原距离矩阵的全局解.该算法的结果与CMDS完全一致.当样本维数远小于样本个数时,其时间复杂度仅为Θ(nlgn).与CMDS算法相比,该算法的速度大大提高,从而使MDS可应用于更大规模数据集.